CM-4012F0-AER-TS00CFBA2

Datasheet

manufacturer	OnTime Networks
series	CM-4012F0-AER
port count	12
port speed	10/100/1000
height (in)	1.770
width (in)	5.870
depth (in)	3.740
weight (lbs)	2.050
power (W)	12
operating temperature (°C)	-40°C - +71°C
input voltage (V)	22V - 32V DC (28V)
connector type	Mighty Mouse 37 pins
form factor	Non Standard (Enclosed)
management	Managed L2
production status	Active
country of origin	-

Detailed Specifications

Overview: The CM-4012F0 AER Series is a line of ruggedized managed gigabit Ethernet switches from OnTime Networks, specifically engineered to operate reliably in the harsh climates and electrically noisy environments of military aircraft. These flight-rated switches are designed and tested to withstand extreme shock and vibration, wide temperature and humidity ranges, dust and water exposure, noisy EMI, and dirty power. The CM-4012F0 AER is qualified for temperatures of -55°C to +85°C, altitudes up to 85,000 ft, and provides 250ms hold-over capability where configured. It is intended for airborne platforms requiring a compact, rugged, managed switching solution with PTP time synchronization and advanced network management. Key Specifications: - Port configuration: 12 × 10/100/1000Base-T Ethernet ports via 3× Mighty Mouse 37-pin connectors - Power input: 28VDC nominal (22–32VDC operating range) - Power consumption: 12 W typical - Power connector: 10-pin MMP (2M 801-011-07ZNU7-10PA), screw type - Connector spacing: According to MIL-STD-1472F - MAC table: 8192 MAC addresses - Priority queues: 8 - Switch fabric: Store-and-forward, full wire speed on all ports - Operating temperature: -40°C to +71°C (per MIL-STD-810G 501.5, 502.5, 503.5) - Storage temperature: -40°C to +85°C (per MIL-STD-810G 502.5) - Altitude: 85,000 ft (per MIL-STD-810G 500.5) - Enclosure: Aluminum case - Dimensions: 149 mm (W) × 95 mm (D) × 45 mm (H) / 5.86 in (W) × 3.74 in (D) × 1.78 in (H) - Weight: 930 g / 2.05 lbs - Surface finish: Powder paint on top of SurTec 650 - Power protection: Overload current protection and reverse polarity protection - Hold-up: No power hold-up (standard); 250ms hold-up available as an option - Data Zeroization: Erases non-volatile flash memory and restores board to factory default configuration; available via HTTP and CLI Qualifications/Compliance Standards: - MIL-STD-461F: CE102, Conducted Emission, 10 kHz – 10 MHz, power leads - MIL-STD-461F/G: CS101, Conducted Susceptibility, power leads; CS114, Bulk Cable Injection, 10 kHz – 200 MHz; CS115, Bulk Cable Injection, 10 kHz – 200 MHz; CS116, Damped Sinusoidal Transients, Cables and Power Leads, 10 kHz – 100 MHz; CS118, Personnel Borne Electrostatic Discharge (ESD) - MIL-STD-461F: RE101, Radiated Emission, Magnetic Field, 30 Hz – 100 kHz, Army; RE102, Radiated Emission, Electric Field - MIL-STD-461F: RS103, Radiated Susceptibility, 2 MHz – 40 MHz, 200 V/m - Power input: MIL-STD-1275E - Operational temperature: MIL-STD-810G 501.5, 502.5, 503.5, -40°C to +71°C - Storage temperature: MIL-STD-810G 502.5, -40°C to +85°C - Altitude: MIL-STD-810G 500.5, 85,000 ft - Operational vibration: MIL-STD-810G 514.6, procedure I (up to 10g) - Shock: MIL-STD-810G 516.6, procedure V (40g, 11ms); 516.4, procedure 1 (30g, 11ms) - Acceleration loads: MIL-STD-810G Method 513.6 (operational: 24g, ultimate load: 35.9g) - Connector spacing: MIL-STD-1472F - Approved for military environmental and EMC requirements Management Protocols: - Network management: HTTP/HTTPS, telnet/SSH, CLI, and SNMP v1/v2/v3 - Event notification: Syslog and SNMP trap - Built-in test: Built-in test procedure performed at boot time; continuous BIT procedure when device is powered - Data zeroization via HTTP and CLI Industrial Protocol Support: - IEEE 802.3x for Flow control - IEEE 802.3ad for LACP (Link Aggregation Control Protocol) - IEEE 802.1D for STP (Spanning Tree Protocol) - IEEE 802.1p for COS (Class of Service) - IEEE 802.1Q for VLAN Tagging - IEEE 802.1w for RSTP (Rapid Spanning Tree Protocol) - IEEE 802.1s for MSTP (Multiple Spanning Tree Protocol) - IEEE 802.1X for Authentication - IEEE 802.1AB for LLDP (Link Layer Discovery Protocol) - IEEE 1588 (PTPv1 and PTPv2) with PTP version translation (v1/v2) support, Transparent Clock (TC) - IGMP snooping (up to 1024 multicast filters) or static multicast filter setting - DHCP - TOS/Diffserv supported - Quality of Service (802.1Q) for real-time traffic - VLAN (802.1Q) with VLAN tagging and MVR - Port rate limiting - Port configuration, status, statistics, monitoring, security Switching Capacity: - Store-and-forward switching with full wire speed on all ports - 8192 MAC address table - 8 priority queues - Up to 1024 multicast filters via IGMP snooping or static configuration Software & Management: - Security features: Enable/disable ports, MAC-based port security; port-based network access control (802.1x); VLAN (802.1Q) to segregate and secure network traffic; RADIUS centralized password management; SNMPv3 encrypted authentication and access security - Management interfaces: HTTP/HTTPS, telnet/SSH, CLI, SNMP v1/v2/v3 - Event notification: Syslog and SNMP trap - Port mirroring - Enhanced watchdog features - Built-in test: boot-time BIT and continuous BIT when powered - Data zeroization: erase non-volatile flash memory and restore factory default configuration via HTTP and CLI - NTP server Product Series Comparison: - CM-4012F0-AER-TS00CPBA0: 149×95×45 mm form factor with LEDs; no power hold-up - CM-4012F0-AER-TS00CFBA0: 149×95×45 mm form factor; no power hold-up - CM-4012F0-AER-TS00CPBA2: 149×95×45 mm form factor with LEDs; includes 250ms power hold-up - CM-4012F0-AER-TS00CFBA2: 149×95×45 mm form factor; includes 250ms power hold-up All variants share the same 12-port 10/100/1000Base-T configuration, 28VDC power input, environmental qualifications, and management features.